CUBE® Micro Station User Guide

Wiring CUBE Micro Station

Step-By-Step

  1. Shutdown the CUBE Micro Station using the power switch and unplug the unit from the wall.
  2. Unlock and open the CUBE Micro Station door.
  3. Remove the Device Modules from the unit and set them to the side.
  4. Lifting up from the center cut-out, remove the AC Adapter Storage Cover and set it to the side.
  5. One-by-one, plug each AC adapter into one of the ten (10) AC outlets.
  6. Carefully, route each power cable through the tray and out through a corresponding hole on the lower front portion of the unit.
  7. Replace the AC Adapter Storage Cover, making sure to wrap it over the front, back and side edges of the AC Storage Compartment.
  8. Return the Device Modules to the CUBE Micro Station.
  9. Insert ten (10) devices into the slot dividers, connecting each into a corresponding AC power adapter.
  10. Connect the main CUBE Micro Station power cable into the wall.
  11. Toggle the power switch to ON ("RESET").

AdapterCompartment_W-Adapters_005

Important Information

  • Be sure to wrap each adapter as efficiently as possible to make the most out of the space provided for the adapters.
  • Cables that are not plugged into devices can rest in the front lower pocket of the tray to stay out of the way of the door.
  • When toggled ON and connected, the power switch will light up to indicate the CUBE Micro Station is powered.
  • NOTE - The middle divider is not intended for use with a device as it would rest on the separation between the two Device Modules. This product is only designed for use with ten (10) devices.